This page is the summary of page 267 of the ebook "COSEL Power Supply, Noise Filter 2025 Product Catalog."
You can click "Open This Page" or "Open 1st Page" button, and open the ebook.
COSEL Power Supply, Noise Filter 2025 Product Catalog
TEPS-seriesPin Configuration?TEPS10F/TEPS20F2AC(N)Bottom view3＋Vout4－VoutNo. Pin connection Function1 AC(L)AC input2 AC(N)3＋Vout＋DC output4－Vout－DC output1AC(L)?TEPS45F/TEPS65F2AC(N)3＋VoutBottom view4－Vout1AC(L)TEPSImplementation・Mounting MethodMounting method!When two or more power supplies are used side by side, position them with proper intervals to allow enough air ventilation. The temperaturearound each power supply should not exceed the temperature range shown in derating curve.!Standard model can be mounted in the mounting position shown in the fi gure below.(A)(B)(C)(D)(E)(F)InputOutputInputOutputInputInputStandard positionInputOutputOutputInput!Option-N model can be mounted in the mounting position shown in the figure below. The installation of (F) possible only forced air cooling.(A)(B)(C)(D)(E)(F)InputOutputInputOutputInputInputStandard positionInputOutputOutputInput!Avoid placing the AC input line pattern layout underneath the unit.It will increase the line conducted noise. Make sure to leave an ampledistance between the line pattern layout and the unit. Also avoid placing the DC output line pattern underneath the unit because it mayincrease the output noise. Lay out the pattern away from the unit.!When installing the components (inclusive chassis) or pattern which is a foreign potentials around the unit, keep the distance for morethan 5mm (except -N model).AC(L)Top viewd1d1d1RecommendedAC(N)-Vout+VoutRecommendedd1Not Recommendedd1d1=5mm min!Do not touch any SMD components on the unit and soldering points.(a) Side view(b) Top view? 265 ?TEPS-17
