Summary
COSEL Power Supply, Noise Filter 2025 Product Catalog
MG1R5,MG3,MG6,MG10-seriesPin configuration?MG1R5/MG3 Single Output1 2 4 6(a) Standard1 2 4 5 6(b) Option : Y2Pin No.Pin NameFunction1-Vin-DC Input2+Vin+DC Input4+Vout+DC OutputNPNo Pin5Output Voltage AdjustmentTRM(Option:Refer to instruction manual 1.5)6-Vout-DC Output?MG1R5/MG3 Dual Output1 2 4 5 6Pin No.Pin NameFunction1-Vin-DC Input2+Vin+DC Input4+Vout+DC Output5COMGND of Output Voltage6-Vout-DC OutputMG?MG6/MG10 Single Output, Dual Output1 2 3 5 6 7 8(a) Single Output, Dual OutputPin No.Pin NameFunction1-Vin-DC Input2+Vin+DC Input3RCRemote ON/OFFNCNo Connect5Output Voltage AdjustmentTRM(Option:Refer to instruction manual 1.5)6+Vout+DC Output78Assembling and Installation MethodInstallation!When two or more power supplies are used side by side, position them with proper intervals to allow enough air ventilation. Ambient temperaturearound each power supply should not exceed the temperature range shown in“Derating”.Soldering Conditions(1) Flow Soldering : 260a 15 seconds or less(2) Soldering Iron : maximum 360a 5 seconds or lessStress to Pin!Applying excessive stress to the input or output pins of the powermodule may damage internal connections. Avoid applying stress inexcess of that shown in right fi gure.!Input/output pin are soldered to the PCB internally.Do not pull or bend a lead powerfully.19.6N (2kgf) or less!If it is expected that stress is applied to the input/output pin due to vibration or impact, reduce the stress to the pin by taking such measuresas fi xing the unit to the PCB by silicone rubber, etc.!Due to prevent failure, PS should not be pulled after soldering with PCB.MG-42? 358 ?
