Summary
COSEL Power Supply, Noise Filter 2025 Product Catalog
MG15,MG30,MG40,MG80-seriesMG?MG15/MG40 Single Output and Dual (±) OutputInputInput321321RC-Vin+Vin-VoutTRM+Vout(a) Single OutputRC-Vin+Vin-VoutCOM+Vout(b) Dual (±) Output654654LoadLoadLoadLoad?MG30/MG80 Single Output and Dual (±) OutputInputInputPin configuration321321RC-Vin+VinRC-Vin+Vin(a) Single Output(b) Dual (±) OutputTRM-Vout+Vout-VoutCOM+Vout654654LoadLoadLoadLoadPin No.Pin NameFunction1+Vin+DC Input2-Vin-DC Input3RCRemote ON/OFF4+Vout+DC Output5 TRM Output Voltage Adjustment (Refer toinstruction manual 1.5)COMGND of Output Voltage (for Dual Output)6-Vout-DC OutputPin No.Pin NameFunction1+Vin+DC Input2-Vin-DC Input3RCRemote ON/OFF4+Vout+DC Output56 TRM Output Voltage Adjustment (Refer toinstruction manual 1.5)-Vout-DC Output (for Dual Output)Assembling and Installation MethodInstallation!When two or more power supplies are used side by side, position them with proper intervals to allow enough air ventilation. Ambient temperaturearound each power supply should not exceed the temperature range shown in“Derating”.Soldering Conditions(1) Flow Soldering : 260a 15 seconds or less(2) Soldering Iron : maximum 360a 5 seconds or lessStress to Pin!Applying excessive stress to the input or output pins of the power module may damage internalconnections. Avoid applying stress in excess of that shown in right fi gure.!Input/output pin are soldered to the PCB internally. Do not pull or bend a lead powerfully.!If it is expected that stress is applied to the input/output pin due to vibration or impact, reducethe stress to the pin by taking such measures as fi xing the unit to the PCB by silicone rubber,etc.!Due to prevent failure, PS should not be pulled after soldering with PCB.19.6N (2kgf)or less19.6N (2kgf)or lessMG-77? 388 ?
