This page is the summary of page 510 of the ebook "COSEL Power Supply, Noise Filter 2025 Product Catalog."
You can click "Open This Page" or "Open 1st Page" button, and open the ebook.
COSEL Power Supply, Noise Filter 2025 Product Catalog
CHS-seriesImplementation・Mounting MethodMounting method!The unit can be mounted in any direction. When two or more power supplies are used side by side, position them with proper intervals toallow enough air ventilation. The temperature around each power supply should not exceed the temperature range shown in InstractionMaunal 8.!Avoid placing the DC input line pattern layout underneath the unit.It will increase the line conducted noise. Make sure to leave an ampledistance between the line pattern layout and the unit. Also avoid placing the DC output line pattern underneath the unit because it may increasethe output noise. Lay out the pattern away from the unit.!Avoid placing the signal line pattern layout underneath the unit because the power supply might become unstable.Lay out the pattern away from the unit.!Avoid placing pattern layout in hatched area shown in below to insulate between pattern and power supply.7 5+VINRC131-VIN2 10+VOUT+STRM-S-VOUT5 14+VINRC-VIN+VOUT+STRM-S-VOUT+VINRC-VIN726.2+VOUT+STRM-S-VOUT(a) CHS60(b) CHS80(C) CHS1205 2437 81.548CHS+VINRC-VIN+VOUT+STRM-S-VOUT+VINRC-VIN+VOUT+STRM-S-VOUT(d) CHS200(e) CHS300/CHS380841841+VINRC-VIN+VOUT+STRM-S-VOUT+VINRC-VIN-VOUT+VOUT+STRM-S-VOUT+VOUT(f) CHS400/CHS500(g) CHS700Dimensions in mmAutomatic Mounting (CHS series:option S)!To mount CHS series automatically, use the inductor area near the output pin as an adsorption point. Please see the ExternalView for details of the adsorption point. If the bottom dead point of a suction nozzle is too low when mounting excessive force isapplied to the inductor, it could cause damage. Please mount carefully.CHS-28? 508 ?
