title: COSEL Power Supply, Noise Filter 2025 Product Catalog

Summary

COSEL Power Supply, Noise Filter 2025 Product Catalog

TUXS-seriesPin Configuration1AC12AC23BCR4＋BC5－BC*Bottom view2-FG8－VOUT7TRM6＋VOUTNo.PinConnectionFunction1 AC1AC input2 AC23 BCR +BC output4 +BC +BC output5 -BC -BC output6 +VOUT +DC output7 TRM Adjustment of output voltage8 -VOUT -DC output- FG Mounting hole (FG)Implementation・Mounting MethodMounting methodTUXS! The unit can be mounted in any direction. When two or more power supplies are used side by side, position them with proper intervals toallow enough air ventilation. Aluminum base plate temperature of each power supply should not exceed the temperature range shown in?Derating”.! Avoid placing the AC input line pattern layout underneath the unit. It will increase the line conducted noise. Make sure to leave an ampledistance between the line pattern layout and the unit. Also avoid placing the DC output line pattern underneath the unit because it mayincrease the output noise. Lay out the pattern away from the unit.! Avoid placing the signal line pattern layout underneath the unit because the power supply might become unstable. Lay out the patternaway from the unit.! High-frequency noise radiates directly from the unit to the atmosphere. Therefore, design the shield pattern on the printed circuit boardand connect it to FG.The shield pattern prevents noise radiation.! When a heat sink cannot be fi xed on the base plate side, orderMounting holethe power module with ?-T”option. A heat sink can be mounted byStandard M3 tappedaffi xing a M3 tap on the heat sink. Please make sure a mountingOptional : -T f3.4 thruhole will be connected to a grounding capacitor CY.Stress onto the pins!When too much stress is applied to the pins may damage internalconnections. Avoid applying stress in excess of that shown in rightfi gure.!The pins are soldered onto the internal PCB.Therefore, Do not bend or pull the leads with excessive force.!Mounting hole diameter of PCB should be 3.5mm to reduce thestress to the pins.!Fix the unit on PCB (fi xing fi ttings) by screws to reduce the stressto the pins. Be sure to mount the unit fi rst, then solder the unit.Less than19.6N(2kgf)Less than19.6N(2kgf)Less than19.6N(2kgf)Soldering!Flow soldering!Soldering iron (26W): 260Cless than 15 seconds.: 450Cless than 5 seconds.TUXS-6? 576 ?